PRS-M3DTEX for DJI M3D and M3TD
  • PRS-M3DTEX for DJI M3D and M3TD
    • Revision Notes
    • Important Notices
    • Terms, Acronyms, Abbreviations
    • Safety Instructions
    • PRS-M3DTEX Limitations
    • PRS-M3DTEX Overview
    • Features & Specifications
    • System Diagram
    • Installation
    • Power & Charging
    • Firmware Updates
    • AVSS Assistant - Additional Functions
    • Status Indications - Remote Controller/FlightHub 2
    • Calibration Processes
    • Emergency Trigger Button (V3.6.3 or Earlier)
    • Geofencing
    • Operating Procedures
    • Maintenance & Care
    • Frequently Asked Questions
    • Warranty
    • Parachute Pod™ Deployment Procedures
    • Customer Support
Powered by GitBook
On this page
  • Post-Flight (Monthly)
  • Storage
  • Extended Storage Considerations
  • External FTS Maintenance
Export as PDF
  1. PRS-M3DTEX for DJI M3D and M3TD

Maintenance & Care

Maintenance and inspection intervals of the AVSS PRS-M3DTEX are required to maximize the safety of each flight and ensure proper functionality for parachute deployment whenever it may be required. The PRS-M3DTEX’s Parachute Pod™ is intended as a single-use item that must be repacked in either twelve (12) month intervals, or after a deployment.

Post-Flight (Monthly)

  • Visually inspect the PRS-M3DTEX to ensure there is no damage.

Storage

  • Always ensure the power is off.

  • Make sure the unit is clean and dry before putting in the case.

Extended Storage Considerations

  1. Store in a dry room that is at room temperature.

  2. Uninstall the AVSS PRS-M3DTEX assembly from the DJI M3D/T drone.

  3. Visually inspect the USB-C located on the underside of the PRS-M3DTEX. Check against signs of corrosion, dust/dirt buildup, wear, or any other types of abnormalities.

  4. Inspect the strap attachment and verify the mounting screw remains secured, and that the strap is free of damage.

  5. If any of the above defects are present during the 18 month inspection period, contact AVSS for further information.

External FTS Maintenance

  • MAKE SURE ALL CONNECTORS ARE PROPERLY ATTACHED THE EFTS Module, AND PRS-M3DTEX

  • TO DETACH FLIGHT TERMINATION SYSTEM, REMOVE THE PRS FROM THE TOP OF THE DRONE, THEN UNCLIP THE BATTERY CLIPS ON THE BATTERY. GENTLY SLIDE THE BATTERY FROM THE DJI M3D/T COMPARTMENT.

  • Do not leave metal terminals exposed to open air when not in use .

  • After exceeding the maximum number of FTS activations contact AVSS to determine if a servicing of the FTS is required.

  • Always update the PRS-M3DTEX to the latest firmware version

PreviousOperating ProceduresNextFrequently Asked Questions

Last updated 2 months ago