PRS-M3DTEX for DJI M3D and M3TD
  • PRS-M3DTEX for DJI M3D and M3TD
    • Revision Notes
    • Important Notices
    • Terms, Acronyms, Abbreviations
    • Safety Instructions
    • PRS-M3DTEX Limitations
    • PRS-M3DTEX Overview
    • Features & Specifications
    • System Diagram
    • Installation
    • Power & Charging
    • Firmware Updates
    • AVSS Assistant - Additional Functions
    • Status Indications - Remote Controller/FlightHub 2
    • Calibration Processes
    • Geofencing
    • Operating Procedures
    • Maintenance & Care
    • Frequently Asked Questions
    • Warranty
    • Parachute Pod™ Deployment Procedures
    • Customer Support
Powered by GitBook
  1. PRS-M3DTEX for DJI M3D and M3TD

Frequently Asked Questions

PreviousMaintenance & CareNextWarranty

Last updated 6 days ago

1

How do I register my PRS-M3DTEX?

Go to .

2

When does the ATS Arm?

34 meters (111.5 ft).

3

When does the PRS-M3DTEX return to a standby state?

The ATS is temporarily disabled when the Drone is within five (5) meters (16 feet) of the ground or any obstacle below the drone. If this sensor is not available then the ATS will disarm after landing for five (5) seconds. NOTE: ENSURE THAT THE PSDK WINDOW DISPLAYS THE "DISARMED" MESSAGE BEFORE APPROACHING THE DRONE.

4

Is the PRS-M3DTEX compatible with Flight Hub 2?

Yes, the PRS-M3DTEX is compatible with FlightHub 2 and Flytbase.

https://www.avss.co/products/product-registration/